192
Chapter 4 Remote Interface Reference
Amplitude Modulation (AM) Commands
4
AM:STATe {OFF|ON}
AM:STATe?
Disable or enable AM. To avoid multiple waveform changes, you can
enable AM after you have set up the other modulation parameters.
The default is OFF. The :STAT? query returns “0” (OFF) or “1” (ON).
• The function generator will allow only one modulation mode to be
enabled at a time. For example, you cannot enable AM and FM at the
same time. When you enable AM, the previous modulation mode is
turned off.
• The function generator will not allow AM to be enabled at the same
time that sweep or burst is enabled. When you enable AM, the sweep
or burst mode is turned off.
33210A users guide.book Page 192 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
