202
Chapter 4 Remote Interface Reference
Pulse Width Modulation (PWM) Commands
4
PWM:STATe {OFF|ON}
PWM:STATe?
Disable or enable PWM. To avoid multiple waveform changes, you can
enable PWM after you have set up the other modulation parameters.
The default is OFF. The :STAT? query returns “0” (OFF) or “1” (ON).
• The function generator will allow only one modulation mode to be
enabled at a time. For example, you cannot enable PWM and AM at
the same time. When you enable PWM, the previous modulation
mode is turned off.
• The function generator will not allow PWM to be enabled at the same
time that sweep or burst is enabled. When you enable PWM, the
sweep or burst mode is turned off.
• PWM is allowed only when pulse is the selected function.
33210A users guide.book Page 202 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
