243
Chapter 4 Remote Interface Reference
Interface Configuration Commands
4
LAN Interface Commands:
SYSTem:COMMunicate:LAN:AUTOip[:STATe] {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:AUTOip[:STATe]?
Disables or enables use of the Auto-IP standard to automatically assign
an IP address to the 33210A. The factory setting is enabled (ON). The
query returns “0” (OFF) or “1” (ON).
• If you change the Auto-IP setting, you must cycle power on the
instrument to activate the new setting.
• Auto-IP allocates IP addresses from the link-local address range
(169.254.xxx.xxx).
• The Auto-IP setting is stored in non-volatile memory, and does not
change when power has been off, or after an instrument reset (*RST).
SYSTem:COMMunicate:LAN:IPADdress <
address
>
SYSTem:COMMunicate:LAN:IPADdress?
Assigns a static Internet Protocol (IP) address for the 33210A, which is
used if DHCP or Auto-IP cannot assign an IP address. The factory
setting is “169.254.2.20”. See your network administrator for a valid IP
address to use. The query returns the current static IP address.
• If you change the IP address setting, you must cycle power on the
instrument to activate the new setting.
• The IP address is stored in non-volatile memory, and does not change
when power has been off, or after an instrument reset (*RST).
33210A users guide.book Page 243 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
