Keysight Infiniium MXR Series - Page 5

Keysight Infiniium MXR/EXR-Series Real-Time Oscilloscopes User's Guide 5
position, zoom window, and time navigation), vertical settings (scaling down to
1 mV/div in hardware and offset), multiple markers (to check voltage or
Δ-time
at any point on a waveform), trigger level, digital channels, protocol decode,
clearing acquisitions from the display, and more.
Knobs are pushable for making quick selections.
• 15.6 inch color 1920x1080 (FHD) capacitive touch screen display with
multi-touch (gestures), handles, and resizing allows oscilloscope operation
without an external pointing device.
• High-capacity removable solid state hard drive for fast boot-up, storing setups,
and saving measurement results.
• USB 3.0 and LAN ports make printing, saving, and sharing data easy.
• VGA and DisplayPort ports on the motherboard I/O panel for displaying the
screen on a different monitor.
• 64-bit Windows operating system and graphical user interface with familiar
menus, toolbars, etc. Ability to install other Windows applications like vector
signal analysis (VSA) software.
• Eight analog channel waveform memories and one digital channels waveform
memory for comparing with other channels or math waveforms.
• More than 50 automated measurements and measurement statistics.
• Up to 16 math function waveforms selectable from these operations: add,
subtract, multiply, divide, d/dt, integrate, invert, FFT magnitude, FFT phase,
magnify/duplicate, square, square root, absolute value, low pass filter, high
pass filter, averaged value, smoothing, envelope, magnify, maximum,
minimum, peak-peak, measurement trend, bus chart, and user-defined
functions with MATLAB analysis.
• New analysis tools including: Fault Hunter and Power Analysis.
• Legacy Infiniium analysis tools including: histograms, mask testing (now with
multiple masks for separate waveforms), jitter, real-time eye, equalization,
crosstalk, and phase noise.
• Supports many compliance testing applications for technologies like:
100BASE-T1, 1000BASE-T1, 10/100/1G Ethernet, 10GBASE-T, 10GBASE-CX4,
Broad-R Reach, CPRI, DDR2/LPDDR2, DDR3/LPDDR3, Energy Efficient
Ethernet, HDMI, MGBASE-T (2.5G/5G), MIPI C-PHY, MIPI D-PHY, MIPI M-PHY,
MOST, NBASE-T (2.5G/5G), OBSAI, ONFI, PCI Express Gen 1-4, Serial RapidIO,
TC8 (OPEN), USB 2.0, and XAUI.