Basic Operation
Remote Control
34
PC Connection
The analyzer provides the USB (Universal Serial Bus)
connection and allows you to set up a remote operation
environment via the USB, LAN or optional GPIB interface
with a controller computer.
Connecting the N9320B to a PC via the USB Port
Please refer to the following steps to finish the connection:
1 Switch on the N9320B
2 Connect the analyzer to a PC with a USB cable.
3 The PC finds your N9320B as a new hardware and prompts
a message saying “Found new hardware...”. A Found New
Hardware Wizard is initiated immediately.
To Next Page
Loading...
