37
Basic Operation
Remote Control
7 Check “*IDN query” and press “Identify Instrument”. The
instrument information shows the firmware revision and
product number. The analyzer is ready for your further
programming..
Connecting the N9320B to a PC via the GPIB port
Please refer to the following steps to connect the instrument
via the GPIB port:
1. Switch on the analyzer.
2. Connect the analyzer and the PC with the GPIB cable.
3. Press > {More} > {More} > {GPIB Address} to set the
GPIB address. The available input range is from 0 to 31.
4. Press > {More} > {IO Config} > {GPIB} to set the GPIB
connector as the IO connector.
Then, the analyzer is connected via the GPIB port and ready
for your further use.
Preset/
System
Preset/
System
To Next Page
Loading...
