Why does my KFI SE35 motor run slowly?
If your KFI Winches motor runs slowly or without normal power, it could be due to worn brushes. In this case, you should get a replacement End-Cap #A-CAPKIT. Another possible cause is loose or corroded cable connections, so clean, tighten, or replace them.
What to do if my KFI SE35 Winches contactor clicks but the winch does not run?
If the contactor clicks but the KFI Winches does not run, double check your winch wiring diagram to make sure all wires are correctly connected. Also, ensure that the hand remote / dash rocker wires are correctly connected: green to green and black to black.
Why is my KFI SE35 Winches motor overheating?
Your KFI Winches motor may be overheating because the winch running time is too long. Allow the winch to cool down periodically.
How to fix KFI Winches that runs only one way?
If your KFI Winches runs only one way, it might be due to a defective or stuck contactor. Try tapping the contactor to loosen the plungers, and then repair or replace the contactor if needed. It could also be a defective switch assembly, which would require replacement. Another reason may be a contactor issue. Double check your winch wiring diagram to ensure all wires are correctly connected.
What to do if KFI SE35 Winches motor runs but the cable is not moving?
If the KFI Winches motor runs but the cable isn't moving, ensure the winch is engaged by rotating the clutch cap to the “engage” position. Another possible cause is a broken coupler or stripped shaft, which would require you to replace the coupler or shaft.
Covers warnings on towing, capacity limits, vehicle specs, lifting, and safe operating distances.
Details safe practices for battery handling, cable re-spooling, and using gloves.
Guides on how to mount the winch unit and its contactor.
Instructions for securely mounting the handlebar control switch.
Details the process of wiring the winch, contactor, and switches.
A detailed, step-by-step process for performing winching operations safely.
Provides a table of common problems, their causes, and suggested solutions.
General| Motor | Series Wound |
|---|---|
| Fairlead | Roller |
| Rated Line Pull | 3500 lbs |
| Cable | Steel |
| Rope Capacity | 50 ft |
| Voltage | 12V |
To Next Page
