KFI STEALTH SE45-R2 User Manual

6
SE45-R2
Mounting bolts must be SAE grade 5 or better
and torque to 17 ft. lbs.
Before you start to install this winch,
disconnect the vehicle ground and positive
leads from the battery.
This KFI 4,500 lb winch is designed with a bolt
pattern that is standard in this class of winch.
Many winch mounting kits are available that
utilize this bolt pattern for the most popular
ATV’s and UTV’s. You can nd most of the
ATV/UTV winch mounts on our Website
www.kproducts.com
1. Install the winch and fairlead with the
supplied hardware per the instructions
provided with the model specic mounting
kit or prepare a at, secure mounting
location for the winch.
Step 2-Mount the Contactor
1. Find a location for the contactor. If the
Model specic mounting kit does not indicate
a recommended contactor location, then
it is recommended that the contactor be
mounted close to the battery in a clean dry
location. Make sure the location you chose
allows sufcient clearance from all metal
components. Drill mounting holes if required.
Once location is found do not install until all
wiring is completed.
Step 3-UTV Dash Mounted
Rocker Switch Kit
1. Most UTV’s and SxS’s have predened
switch locations that are pre-scribed or
marked for mounting and require nish cut
with a knife.
2. Use the cut-out dimensions shown below
to cut-out the switch location If your dash
doesn’t have the pre-scribed areas
3. Once your switch is mounted you can route
the wires back to where your contactor is
located.
4. Splice the end of the red wire to an ignition
(keyed) controlled power source using the
supplied wire splice. You may need to use a
test light to locate a suitable wire. The wire
should only have power when the key is in
the ON position.
Step 1-Mount the Winch
Installation
CAUTION
WARNING
2. Attach the winch using the M8 x 25 or 30
bolts and washers through the fairlead
bracket or model specic mount and then
into the winch.
3. Disengage the clutch by rotating the clutch
cap to the “FREESPOOL” position. Release
the synthetic rope and pull through the roller
fairlead.
4. Attach the clevis hook and hand strap to the
cable.
NOTE
If you chose not to use a model specic
mounting kit, you will need to drill holes in the
structural support of the vehicle. Be certain
that your structural support will stand up to the
pulling forces of this winch.
Installation
1"
3/16"
1 5/8"
13/16"
Not to scale. Do NOT use as a template

KFI STEALTH SE45-R2 Specifications

General

Brand	KFI
Model	STEALTH SE45-R2
Category	Winches
Language	English