SAFETY BELTS
PRE-TENSIONER SEAT
BELT (IF EQUIPPED)
Your vehicle is equipped with driver’s
and front passenger’s pre-tensioner seat
belts. The purpose of the pre-tensioner is
to make sure that the seat belts fit tightly
against the occupant’s body in certain
frontal collisions.
The pre-tensioner seat belts can be
activated alone or, together with the
airbags. where the frontal collision is
severe enough.
The pre-tensioner seat belt operates in
the same way as an Emergency Locking
Retractor(ELR) type of seat belt. When
the vehicle stops suddenly, or if the
occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position. However, incertain frontal
collisions, the pretensioner will activate
and pull the seat belt into tighter contact
against the occupant’s body.
The seat belt pre-tensioner system
consists mainly of the following
components.
Their locations are shown in the
illustration.
1. SRS airbag warning light.
2. Seatbelt pre-tensioner assembly.
3. SRS control module.
WARNING:
To obtain maximum benefit from a
pre-tensioner seat belt:
1. The seat belt must be worn
correctly.
2. The seat belt must be adjusted
to the correct position.
3-23
EMSA3080
EMSA3021
Driver’s side airbag
2
1
3
Passenger’s
side airbag
To Next Page
Loading...
