7-33
BULB REPLACEMENT
HEADLIGHT BULB
REPLACEMENT
WARNING - HALOGEN BULBS
• Wear eye protection when
changing a bulb. Allow the bulb
to cool before handling it.
• Halogen bulbs contain
pressurized gas. If broken, a
halogen bulb will explode and
will produce flying pieces of
glass.
• Always handle halogen bulbs
carefully to avoid scratches and
abrasion. If the bulbs are lit,
avoid contact with liquids.
Never touch the glass with bare
hands. Residual oil may cause
the bulb to overheat and burst
when lit. A bulb should be
operated only when installed in
the headlight assembly.
• If a bulb becomes damaged or
cracked, replace it immediately
and carefully dispose it.
1. Remove the headlight bulb cover by
turning it counterclockwise.
2. Disconnect the headlight bulb
electrical connector.
3. Unsnap the headlight bulb retaining
wire.
4. Remove the bulb from the three (3)
slots on the headlight assembly.
EMSA7024 EMSA7025
To Next Page
Loading...
