Securing a Child Restraint
Seat with “Tether Anchor”
System (If equipped)
Child restraint hook holders are located
on the shelf behind the rear seats.
1. Open the tether anchor cover on the
shelf behind the rear seats.
2. Route the child restraint seat strap
over the seatback.
For vehicles with adjustable headrest,
route the tether strap under the
headrest and between the headrest
posts, otherwise route the tether strap
over the top of the seatback.
3. Connect the tether strap hook to the
belonging child restraint hook holder
and tighten to secure the seat.
Securing a Child Restraint
System with “ISOFIX” System
and “Tether Anchorage”
System
ISOFIX is a standardised method of
fitting child seats that eliminates the need
to use the standard adult seat belt to
secure the seat in the vehicle. This
enables a much more secure and positive
location with the added benefit of easier
and quicker installation.
An ISOFIX-seat can only be installed if
it has vehicle-specific approval in
accordance with the requirements of
ECE-R44. For your Kia, the “Kia
ISOFIX GR1 / Kia Duo” and the
“Römer Duo ISOFIX / Britax Duo
ISOFIX” is approved according to the
requirement ECE-R44. This seat has
been tested extensively by Kia and is
recommended for your Kia.
3-33
MMSB3032
2BLE349
To Next Page
Loading...
