12
*IF EQUIPPED
†LEGAL DISCLAIMERS ON BACK INSIDE COVER
ADAS
(Button located on driver’s panel,
left of the steering wheel)
(Blind-spot area
monitoring)
(Vehicle
approaching
at high speed
monitoring)
Blind-Spot Collision Warning (BCW)
†6
Blind-Spot Collision Warning uses rear corner radar sensors in the rear bumper
to monitor and warn the driver if it detects an approaching vehicle in the driver’s
blind spot area and before changing lanes.
The system will activate when the vehicle is traveling
more than 20 mph and will alert the driver if another
vehicle is detected by the radar sensor.
With the Engine Start/Stop button in the ON position,
press the BCW button
A
to turn the system ON. The
button light will illuminate. The outside rearview mirror
warning lights will also illuminate for 3 seconds.
1st-stage warning: When another vehicle is detected within the BCW warning
boundary
B
, a yellow indicator will illuminate on the outside rearview mirrors
C
.
2nd-stage warning: When 1st stage warning is on and the driver activates a
turn signal, a flashing yellow indicator will illuminate on the outside rearview
mirrors and the system will sound an alert.
REMINDERS:
§ BCW will not issue a warning if the vehicle speed is 6 mph or
more above the surrounding vehicles
§ When BCW is ON and the ignition is cycled, BCW returns to its
previous state
§ BCW and RCCW are supplemental systems. Do not solely rely
on these systems and always pay attention the road and its
conditions and drive safely.
See section 5 in the
Owner’s Manual for
more information.
REMINDERS:
§ The RCCA Warning sound can be adjusted in the User Settings*
or the Vehicle Settings* on the audio head unit
§ When vehicle power is cycled, RCCA will remain in the previous
state RCCA can be turned OFF/ON in User Settings
§ RCCA will show a warning if the approaching vehicle speed
is between 2.5-22 mph within sensing range. See owner’s
manual for other conditions
§ RCCA is a supplemental system. Do not solely rely on this
system and always pay attention to the road and its conditions
Rear Cross-Traffic Collision Warning (RCCW)
†6
If Rear Cross-Traffic Collision Warning (RCCW) sensors detect vehicles approaching from the rear left or rear
right side
D
, the system will sound an audible alert, the warning indicators on the outside rearview mirror will
illuminate and a message will appear on the LCD screen. RCCA may activate the Electronic Stability Control
(ESC) to help avoid an imminent collision. RCCA may temporarily apply braking power when an approaching
vehicle is detected within a certain distance next to or behind the vehicle.
RCCW is designed to operate under these conditions:
§ When the vehicle is in Reverse
§ When the vehicle is moving less than 6 mph
A
B
See section 5 in the Owner’s
Manual for more information.
D
C
BLIND-SPOT COLLISION
WARNING VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to inside
cover for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
§ BCW will activate when:
§ The system is turned on
§ Vehicle speed is above approximately 20 mph
§ Other vehicles are detected on the rear sides of the vehicle
QUICK TIP
ADVANCED DRIVER ASSISTANCE SYSTEMS (ADAS)
To Next Page
Loading...
