20
STEERING WHEEL CONTROLS
STEERING WHEEL
CONTROLS
Headlight position
Parking light position
AUTO*
Auto Light* / LBA position
DRL/OFF
OFF or DRL OFF position
Headlight position
Tail Light position
AUTO
Auto Light / LBA-D* /
High Beam Assist*
OFF
OFF position
Headlights & High Beams
AUTO Light – When the light switch is in the AUTO Light position, the tail lights and headlights will turn
ON/OFF automatically depending on the amount of light outside the vehicle.
Low Beam Assist-Dynamic (LBA-D) / Dynamic Bending Light (DBL)* – LBA can help improve visibility
during nighttime driving by aiming the low-beam headlights toward the direction the vehicle is moving. LBA
controls the aiming direction based on steering angle and speed.
When the light switch is in the AUTO light position, LBA will activate.
High Beam Assist (HBA)* – High Beam Assist is designed to automatically adjust the headlight range by
switching between high and low beams based on light detected from other vehicles and road conditions.
To enable HBA, toggle the light switch to the AUTO Light position and turn on the high beams by pushing
the lever away from you. The High Beam Assist indicator will illuminate.
REMINDERS:
§ High Beam Assist does not operate below certain speeds, or in some lighting and driving conditions. Please be aware of your
surroundings and exercise proper road etiquette when operating a vehicle using the high beams.
§ HBA will operate when vehicle speed exceeds 25 mph
§ If the lever is pushed away from you while HBA is operational, HBA will turn off and the high beams will be on continuously. If the lever is
pulled toward you while HBA is operational, HBA will turn off
§ If the light switch is switched to the headlight position, HBA will turn off and low beams will be on continuously
§ DRL only operates during the daytime
Daytime Running Lights (DRL) – DRL can make it easier for others to see the front of your vehicle during
the day. The lights will be on automatically unless one of the following occurs:
§ Headlights are on
§ Parking brake is applied
§ Switch is in the DRL OFF position
§ Engine is turned off
Headlight / High Beam Lever Operation
§ Rotate lever switch to change the headlight function:
§ Press lever away from you to turn high beam headlights ON
§ Pull lever to flash headlights/high beams
REMINDER: When the LBA
indicator illuminates on the
instrument cluster, the LBA is not
working properly. See authorized
Kia dealer for service.
See section 4 in the Owner’s Manual for more information.
*IF EQUIPPED
To Next Page
Loading...
