Headlight position
Parking light position
AUTO*
Auto Light* / LBA position
DRL/OFF
OFF or DRL OFF position
Headlight position
Tail Light position
AUTO
Auto Light / LBA-D* /
High Beam Assist*
OFF
OFF position
Headlights & High Beams
AUTO Light – When the light switch is in the AUTO Light position, the tail lights and headlights will turn
ON/OFF automatically depending on the amount of light outside the vehicle
Low Beam Assist-Dynamic (LBA-D) / Dynamic Bending Light (DBL)* – LBA can help improve visibility
during nighttime driving by aiming the low-beam headlights toward the direction the vehicle is moving LBA
controls the aiming direction based on steering angle and speed
When the light switch is in the AUTO light position, LBA will activate
High Beam Assist (HBA) – High Beam Assist is designed to automatically adjust the headlight range by
switching between high and low beams based on light detected from other vehicles and road conditions
To enable HBA, toggle the light switch to the AUTO Light position and turn on the high beams by pushing
the lever away from you The High Beam Assist indicator will illuminate
Daytime Running Lights (DRL) – DRL can make it easier for others to see the front of your vehicle during
the day The lights will be on automatically unless one of the following occurs:
• Headlights are on
• Parking brake is applied
• Switch is in the DRL OFF position
• Engine is turned off
Headlight / High Beam Lever Operation
• Rotate lever switch to change the headlight function:
• Press lever away from you to turn high beam headlights ON
• Pull lever to ash headlights/high beams
See section 4 in the Owner’s Manual for more information
STEERING WHEEL
CONTROLS
STEERING WHEEL CONTROLS
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE
OPERATING INFORMATION AND SAFETY WARNINGS
*IF EQUIPPED
29
REMINDERS:
• High Beam Assist does not operate below certain speeds, or in some lighting and driving conditions Please be aware of
your surroundings and exercise proper road etiquette when operating a vehicle using the high beams
• HBA will operate when vehicle speed exceeds 25 mph
• If the lever is pushed away from you while HBA is operational, HBA will turn off and the high beams will be on continuously
If the lever is pulled toward you while HBA is operational, HBA will turn off
• If the light switch is switched to the headlight position, HBA will turn off and low beams will be on continuously
• DRL only operates during the daytime
REMINDER: When the
LBA indicator illuminates on
the instrument cluster, the
LBA is not working properly
See authorized Kia dealer
for service
To Next Page
Loading...
