63
6
6
Driving your vehicle Forward Collision-Avoidance Assist (FCA)
(Sensor fusion)
Dirt, snow, or foreign substances on
the lens may adversely affect the
sensing performance of the sensor.
Warning message and warning light
When the sensor cover is blocked
with dirt, snow, or debris, FCA oper
-
ation may temporarily stop. In this
case, the warning message appears
to warn the driver.
This is not a malfunction with FCA.
To operate FCA again, remove the
foreign substances.
FCA may not properly operate in an
area (e.g. open terrain), where any
substances are not detected after
turning ON the engine.
FCA system may not activate with
-
out any warning messages accord
-
ing to driving condition, traffic on
the road, weather, road condition,
etc.
䳜 Do not install any accessories,
such as license plate molding or
sticker, on the sensor area. Nor
arbitrarily replace the bumper.
Those may adversely affect the
sensing performance.
䳜 Always keep the sensor/bumper
area clean.
䳜 Use only soft clothes to wash the
vehicle. Also, do not spray highly
-
pressurized water on the sensor
installed on the bumper.
䳜 Be careful not to apply unneces
-
sary force on the frontal sensor
area. When the sensor moves out
of the correct position due to
external force, the system may
not normally operate even with
-
out the warning light or message.
In this case, have the vehicle
inspected by a professional work
-
shop. Kia recommends to visit an
authorized Kia dealer/service
partner.
䳜 Use only the genuine Kia sensor
cover. Do not arbitrarily apply
paint on the sensor cover.
䳜 Do not tint the window or install
stickers, accessories around the
inside mirror where the camera is
installed.
䳜 Make sure the frontal camera
installation point does not get
wet.
Driving_your_vehicle.fm Page 63 Thursday, November 14, 2019 10:42 PM
To Next Page
Loading...
