EasyManua.ls Logo

Kia XCEED PHEV MY21 - Changing a Tire with TPMS

Kia XCEED PHEV MY21
636 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
What to do in an emergency
147
Tire Pressure Monitoring System (TPMS)
This can interfere with normal
operation of the Tire Pressure
Monitoring System (TPMS).
Changing a tire with TPMS
If you have a flat tire, the low Tire
Pressure and Position telltales will
come on. In this case, have the sys
-
tem checked by a professional
workshop. Kia recommends to visit
an authorized Kia dealer/service
partner.
CAUTION
We recommend that you use the
sealant approved by Kia.
The sealant on the tire pressure
sensor and wheel shall be elemi
-
nated when you replace the tire
with a new one.
Each wheel is equipped with a tire
pressure sensor mounted inside the
tire behind the valve stem. You
must use TPMS specific wheels.
Have your tires serviced by a pro
-
fessional workshop. Kia recom
-
mends to visit an authorized Kia
dealer/service partner.
If you drive the vehicle for about 10
minutes at speeds above 25 km/h
after replaceing the low pressure
tire with the spare tire, one of the
following will happen:
The TPMS malfunction indicator
may blink for approximately 1
minute and then remain continu
-
ously illuminated because the
TPMS sensor is not mounted on
the spare wheel. (changed tire
equipped with a sensor not in the
vehicle)
The TPMS malfunction indicator
will remain continuously illumi
-
nated while driving because the
TPMS sensor is not mounted on
the spare wheel. (changed tire
equipped with a sensor in the
vehicle)
You may not be able to identify a
low tire by simply looking at it.
Always use a good quality tire pres
-
sure gauge to measure the tire's
inflation pressure. Please note that
a tire that is hot (from being driven)
will have a higher pressure mea
-
surement than a tire that is cold
(from sitting stationary for at least
3 hours and driven less than 1 mile
(1.6 km) during that 3 hour period).
Allow the tire to cool before mea
-
suring the inflation pressure. Always
be sure the tire is cold before inflat
-
ing to the recommended pressure.
A cold tire means the vehicle has
been sitting for 3 hours and driven
for less than 1 mile (1.6 km) in that
3 hour period.
CD_PHEV_LHD.book Page 14 Tuesday, November 12, 2019 11:29 PM

Table of Contents

Related product manuals