Kichler Lighting FERRON - Attaching the Fan Blades; Installing Decorative Cover and Nut

ATTACHING THE FAN BLADES
Step 1.Attach the blade to the blade bracket using the screws, blade
support plates, Allen screws, and fiber washers provided. To tighten
the Allen screw by using the Allen wrench provided. (Fig. 15)
Make sure the blade is straight when set on the blade bracket.
Tighten each mounting screw and then repeat this procedure for
each blade.
Fig. 15
Fig. 16
Blades
Allen screws
Allen
wrench
Fiber washers
Blade support
plate
Screws
60" FERRON
TM
| 13
INSTALLING THE DECORATIVE
COVER AND DECORATIVE NUT
Step 1. Attach the decorative cover and decorative nut onto the fan
motor stem. DO NOT OVER TIGHTEN. (Fig. 16)
Decorative cover
Decorative nut