14
9.1 Setting Up a Wireless Alarm Network
Creating an interconnected wireless alarm network is a simple process, with intelligent “self-enrollment”
features, and user-friendly voice prompts.
A. REMOVE ALL DEVICES FROM THEIR PACKAGING
B. POWER UP ALL DEVICES
• Locate the red wheel on the back of the device. Turn the red
wheel to the “ON” position on ALL devices using the white tool
included with the Quick Start Guide.
• Once powered, the light rings will glow red and voice
message will announce, “Ready to connect. Follow Quick Start
instructions.”
C. LANGUAGE SELECTION
• This unit operates in either English or French. To switch your language preference at any time, press
the Test button twice on ALL devices you wish to connect. You should hear one beep for each
button press, followed by a voice message confirming your language selection (“English language
selected” or “Langue française selectionné”). If no language is selected, the voice prompts will
continue in the default / set language.
NOTE: If no further steps are taken within 15 minutes of initial power up, a voice prompt, “No devices
found, not connected” will be heard once, and the wireless function will turn off. The unit will then
perform as a stand alone alarm. See Section 9.3 for re-activating wireless.
D. PICK ONE DEVICE
Press and hold the button on only ONE device until you hear two
beeps. Release button. You will hear “Searching for other devices”.
Figure 9.1-B
ON
ACTIVATION
TOOL
Figure 9.1-C
DON'T press buttons
on other devices
“Searching for
other devices.”
Hold for
5 seconds
To Next Page
Loading...
