17
E. RELAX AND WAIT
• Wait until the new device has connected to the network. Once
connected, the new device will speak, “Success now connected!”
• Once connected, the light ring will glow green.
F. PICK THE INSTALLED DEVICE
Press and hold the button on the INSTALLED device for 5 SECONDS
until you hear two beeps. Release button. ”Sonar” ping will stop.
• Device will announce that setup is complete and the number of
connected devices.
G. SELECT LOCATION AND INSTALL ALARM
After selecting the proper location for your alarm, attach the mounting bracket to the wall or ceiling. To
ensure aesthetic alignment of the alarm with the hallway, or wall, the “A” line on the mounting bracket
must be parallel with the hallway when ceiling mounted, or horizontal when wall mounted.
• Install the alarm fully on the mounting bracket by rotating the alarm in a clockwise direction.
NOTE: The alarm will mount to the bracket in 4 positions (every 90 degrees).
The alarm is now activated! After installation / activation, test your alarm as described in Operation and
Testing section.
WARNING: Fai lure to properly install and activate this alarm will prevent proper operation of this
alarm and will prevent its response to fire hazards.
Figure 9.2-E
Added Device
complete!”
Installed Device
Figure 9.2-D
“Success, now
connected!”
To Next Page
Loading...
Need help?
General
