Chapter 3: Smoke control system programming
VM-1 Smoke Management Application Guide 45
Name: FSCS STATUS LEDS - CORR 9
Inputs:
Monitor, SUPPLY_FAN_OFF_RELAY
Outputs:
Steady, Low, Both, SUPPLY_FAN_OFF_LED
Name: FSCS STATUS LEDS - CORR 10
Inputs:
Trouble, SUPPLY_FAN_OFF_RELAY
Outputs:
Steady, Low, Both, SUPPLY_FAN_TRBL_LED
Controlling fans and dampers
manually
The FSCS is required to provide switches for controlling
fans and dampers manually. Typically, the switches are
disabled until the FSCS has control of the smoke control
system.
The correlation inputs and outputs shown below can be
used to create correlations that demonstrate how to
program manual controls for a supply fan and supply
damper. Refer to Figure 23 on page 38 and Figure 24 on
page 39.
Name: FSCS MANUAL CONTROLS - CORR 1
Inputs:
Startup
Outputs:
Disable, Low, Both, FSCS_SW/LED_STRIP_1
Steady, Low, Both, SUPPLY_FAN_AUTO_SW_LED
Steady, Low, Both,
SUPPLY_DAMPER_AUTO_SW_LED
Name: FSCS MANUAL CONTROLS - CORR 2
Inputs:
Alarm, <all smoke control smoke
detectors>
Outputs:
Enable, Low, Both, FSCS_SW/LED_STRIP_1
Name: FSCS MANUAL CONTROLS - CORR 3
Inputs:
Switch, SUPPLY_FAN_ON_SW
Outputs:
LEDOFF, High, Both,
SUPPLY_FAN_AUTO_SW_LED
STEADY, High, Both, SUPPLY_FAN_ON_SW_LED
ON, Low, High, SUPPLY_FAN_ON_RELAY
Name: FSCS MANUAL CONTROLS - CORR 4
Inputs:
Switch, SUPPLY_FAN_OFF_SW
Outputs:
LEDOFF, High, Both,
SUPPLY_FAN_AUTO_SW_LED
STEADY, High, Both, SUPPLY_FAN_OFF_SW_LED
OFF, High, Both, SUPPLY_FAN_ON_RELAY
ON, High, Both, SUPPLY_FAN_OFF_RELAY
Name: FSCS MANUAL CONTROLS - CORR 5
Inputs:
Switch, SUPPLY_DAMPER_OPEN_SW
Outputs:
LEDOFF, High, Both,
SUPPLY_DAMPER_AUTO_SW_LED
STEADY, High, Both,
SUPPLY_DAMPER_OPEN_SW_LED
ON, High, Both, SUPPLY_DAMPER_OPEN_RELAY
Name: FSCS MANUAL CONTROLS - CORR 6
Inputs:
Switch, SUPPLY_DAMPER_CLOSE_SW
Outputs:
LEDOFF, High, Both,
SUPPLY_DAMPER_AUTO_SW_LED
STEADY, High, Both,
SUPPLY_DAMPER_CLOSE_SW_LED
OFF, High, Both, SUPPLY_DAMPER_OPEN_RELAY
ON, High, Both, SUPPLY_DAMPER_CLOSE_RELAY
To Next Page
Loading...
