FTang_CO110 – 03/03/15 – RCS (24) Périgueux 349 282 095 Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.
MAINTENANCE
Please avoid any aggressive solvent. Please protect the transmitter and its probes from any cleaning product containing formol, that may be used for cleaning
rooms or ducts.
OPTIONS AND ACCESSORIES
●
?2"#*++Power supplyclass 2, 230 Vac input, 24 Vac output
●
?2"#*++ Power supplyclass 2, 230 Vac input, 24 Vdc output
●
"#( configuration software with USB cable
POSITIONING OF THE PROBE
For duct models, the positioning of the probe is important to get accurate measurements: the hole located next to the screw at the end of the probe must face
the air flow.
Procedure to modify the positioning of the end of the probe:
➢
Unscrew the screw.
➢
Turn the end of the probe: the hole must face the air flow.
➢
Replace the screw.
Screw
End of the probe
Hole
),14
PRECAUTIONS FOR USE
Please always use the device in accordance with its intended use and within parameters described in the technical features in order not to compromise the
protection ensured by the device.
To Previous Page
