Kinco CD420 - 1.3 Model Description of Servo Motors and Drivers

108 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

8

1.3.3 Power,Brake and Encoder cable of Motors

Table of Contents

Default Chapter1
- Table of Contents1
Chapter 1 Product Acceptance & Model Description4
Chapter 2 Precautions and Installation Requirements9
Chapter 3 Interfaces and Wirings of CD Driver12
Chapter 4 Digital Operation Panel18
- Introduction18
- Operation on Digital Operation Panel20
  - Example 4-1: Set the Denominator of Electronic Gear Ratio to 10000 with Number System Switching20
  - Example 4-2: Set the Speed to 1000 RPM/-1000 RPM with Separate Regulation of Bits21
Chapter 5 Trial Operation & Parameter Introduction23
- Trial Operation23
- Description of Parameters25
Chapter 6 Operation on Input/Output Ports35
Chapter 7 Mode Operation45
Chapter 8 Control Performance86
- Driver Performance Tuning86
  - Manual Adjustment86
  - Auto Adjustment (Only for Velocity Loops)90
- Oscillation Inhibition92
Chapter 9 Communication94
- Transport Protocol94
- Data Protocol95
  - Download(From Host to Slave)95
  - Upload(From Slave to Host)96
Chapter 10 Troubleshooting97
- Alarm Messages97
- Alarm Causes & Troubleshooting98
Chapter 11 Specification99

Other manuals for Kinco CD420

Manual133 pages

Related product manuals

Kinco CD423-AA-000

Preview: Kinco CD3 Series

Kinco CD3 Series

Preview: Kinco CD2S Series

Kinco CD2S Series

Preview: Kinco JD Series

Kinco JD Series

Kinco FD625-PA-000