Kinco HP043-20DT - Configuration in Software

Kinco-HP
User Manual
59
The following table are the range of signal.Among them,I stand for Actual Current,V stand for
Actual Voltage.
Signal
Output range
User assigned value in program
4-20mA
3.92-20.4mA
I×1000
0-20mA
0-20.4mA
1-5V
0.96-5.1V
V×1000
0-10V
0-10.2V
3.3.3 Configuration in software
Hardware configuration in the software can be used to configure analog channel parameters.
 Address
• The starting address ： Specifies the start byte address that the module occupies in the
address space in the AI region（That's the address of the first channel）.
Each AI point takes 2 bytes in the AI region.therefore，The address must be an
even number.
• length ： The length of the address space occupied by this module.This is a fixed value,
depending on the number of AI channels on the module.
As above，The starting address of CPU module is specified as %AIW0，The module has two AI