Kinco HP043 - Page 2

Kinco-HP
User Manual
2
3.2 PLC................................................................................................................................... 25
3.2.1 introduction................................................................................................................ 25
3.2.2 Install driver of USB programming port....................................................................25
3.2.3 High speed counter.....................................................................................................38
3.2.3.1 Operation Modes and Inputs of the High-speed Counters.................................. 38
3.2.3.2 Control Byte and Status Byte..................................................................................39
3.2.3.3 Preset value (PV value) setting...............................................................................41
3.2.3.4 “CV=PV” Envent No..............................................................................................43
3.2.3.5 How to use high speed counter............................................................................... 44
3.2.4 How to use high speed pulse output.......................................................................... 46
3.2.4.1 High speed pulse output instruction........................................................................47
3.2.4.2 How to use PLS instruction.................................................................................... 47
3.2.4.2.1 High-speed Pulse Output Function of HMI-PLC......................................... 48
3.2.4.2.2 PTO/PWM Register...................................................................................... 50
3.2.4.2.3 PTO Operations..........................................................................................51
3.2.4.2.4 PWM Operations...........................................................................................53
3.2.5 How to Use Position Control Instructions..............................................................54
3.2.5.1 How to Modify the Current Value of Position Control Instructions...................... 54
3.2.5.2 Can it change maximum output frequency when position control instruction is
executing?............................................................................................................................57
3.3 The use of analog quantities............................................................................................. 57
3.3.1 Wiring diagram....................................................................................................... 58
3.3.2 Measurement Ranges and The measured value Representation................................58
3.3.3 Configuration in software.......................................................................................... 59