User Manual
Precautions on rotary switch:
S1 cannot be set to NA; otherwise, the driver will generate an alarm. In this case, turn
off the power, re-set the macro-step values, and turn on the power again to resume
normal.
To set the status of the DIP switch, choose an appropriate straight screwdriver; a
screwdriver of inappropriate size may cause damage to the DIP switch.
When setting the status of the DIP switch, do not apply an axial force; otherwise,
it may cause damage to the DIP switch.
Micro-step smoothing filter setting stored in driver EEPROM,driver will read the state
before working,to determine the Micro-step smoothing filter on or off.It’s enable as
default.
To Next Page
Loading...
