3
Safety Information
1
Read all steps, guides and rules
carefully before installing and
using the Essential.
2
Close or remove PVC containers
and other flammable materials to
prevent fire or explosions.
Provide proper ventilation when
using PVC cleaner or glue.
3
Wear protective eyewear while
installing to prevent potential eye
injury that could be caused by
splattering soldering materials or
metal/plastic shavings.
4
Use a scorch pad to protect any
surface that may be exposed to a
torch flame or excessive heat.
Use only LEAD FREE solder.
5
When installing a plastic
component, install grounding
straps BEFORE the lines are
actually cut to ensure that the
ground is never broken.
6
Use a ladder for all work overhead
beyond your natural reach. If
working continuously at a height
of six feet or more, employ the
appropriate safety devices.
Note: Kinetico recommends that a qualified installer or engineer perform the
installation. Failure to install the system as instructed could void the Limited
Warranty.
Important: Refer to typical installation drawing (figure 1, page 4) before beginning
installation.
Installation
Instructions
To Next Page
Loading...
Need help?
General
