EasyManuals Logo

Kinetico K5 Owner's Manual

Kinetico K5
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
e Kinetico K5 Drinking Water Station is tested and certified by NSF International against
the requirements of NSF/ANSI Standard 42 for the reduction of aesthetic chlorine, taste
and odor and Standard 58 for the reduction of pentavalent arsenic, barium, raduim
226/228, cadmium, copper, cysts (including oocysts of cryptosporidium and cysts of
giardia and entamoeba), fluoride, hexavalent chromium, lead, nitrate/nitrite (with test kit
Part No. 7329), selenium, TDS (commonly comprised of calcium, magnesium, sodium,
iron, manganese, bicarbonate, sulfate and carbonate), trivalent chromium and turbidity.
(See performance data sheet for individual contaminants and reduction performance.)
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected
water that may contain filterable cysts.
e Kinetico K5 Drinking Water Station is acceptable for treatment of influent concentrations of no
more than 27 mg/L nitrate and 3 mg/L nitrite in combination measured as N and are certified for
nitrate/nitrite reduction only for water supplies with a pressure of 280 kPa (40 psi) or greater.
NSF International certify our product performance, and review our manufacturing facility and
procedures to assure product consistency and integrity. ey also assure that our literature accurately
reflects our product capabilities.
e system and installation must comply with state/provincial and local laws and regulations.
US Patent numbers 4,698,164; ,629,568; 4,650,586
Canadian Patent number 1,323,310
System Specications
TDS maximum level 3000 ppm
pH Range: 3-11
Pressure Ranges: 35-120 psi (2.41-8.27 bar),
40 psi (2.76 bar) minimum for Nitrate reduction
Temperature Range 35˚-100˚F (2˚-38˚C)
Water Supply 0-10 grains per gallon hardness, 0 - 0.1 iron
Rated Filter Capacity 500 gallons (1895 L)
(Auxiliary and Postfilter)
Maximum Daily Production Rate 75gpd* (283 Lpd)
Membrane Discharge 1 to 1
Water/Product Water Ration:
Discharge Water/Product 2.8 to 1.0
Water Ratio:
Typical Product Water 40.6 gpd (153.7 Lpd)
Production Rate:
Efficiency Rating
1
24.4%
Recovery Rating
2
39.9%
17

Other manuals for Kinetico K5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kinetico K5 and is the answer not in the manual?

Kinetico K5 Specifications

General IconGeneral
Filter TypeReverse Osmosis
Daily Production Rate50 gallons per day
CertificationsNSF/ANSI 58
Filter Life6-12 months
Waste Water Ratio1:1

Related product manuals