King gates Modus - Product Description; Installation

14
EN
2. Product description
Thisproductistobeusedtoautomatehingedgatesordoors,for
bothresidentialandindustrialuse.
WARNING!
Any other use other than that described and in environmental
conditionsotherthanthoselistedinthismanualistobeconsidered
improperandprohibited!
The product isan electromechanicalgear motor, equipped with a
24Vdirectcurrentmotorpoweredbytheinternalcontrolunitanda
gearboxwithanarticulatedarm.
Intheeventofapowerfailure(black-out),itispossibletomovethe
leavesofthegatebyhandbymanuallyunlockingthegearmotor.
Fig. 1showsallthecomponentspresentinthepack(accordingto
thechosenmodel):
[a]-electromechanicalgearmotor
[b]-armconnectingtothemotor
[c]-armconnectingtotheleaf
[d]-leafsupportbracket
[e]-motorunlockingkey
[f]-wallsupportbrackettosecurethemotor
[g]-metalhardware(screws,washers,etc.)
f
a
b
e
d
g
c
g
Fig. 1
3. Installation
Warning! -TheinstallationofMODUSmustbecarriedoutby
qualiedpersonnel,incompliancewithcurrentregulations,standards
andlaws,andfollowingtheseinstructions.
3.1 - Preliminary checks
Beforeinstallation,alwayscheckthattherearenobrokenproduct
components,thatthemodelselectedisappropriatefortheintended
useandthattheinstallationenvironmentissuitablefortheproduct.
IMPORTANT–Thegearmotorcannotautomateamanualgate
thatdoesnothaveanefcientandsafemechanicalstructure.
Itcannotcorrectdefectsduetobadinstallationorpoormaintenance
ofthegate.
3.2 - Suitability of the gate and
installation environment
•Checkthatthemechanicalstructureofthegateissuitableforthe
installationofanautomationsystemandincompliancewithcurrent
localregulations(ifnecessary,checkthedatafoundonthelabelof
thegate).
•Manuallycloseandopenthegateleaf,tomakesurethatthereis
anappropriatelevelofconstantfrictionduringthewholeopeningor
closingmovement(nopointsrequiringincreasedeffort).
•Checkthatwhenmovedtoanypositionbetweenfullyopenand
fullyclosed,thegateleafkeepsitsbalance,withoutmovements.
•Makesurethat aroundthe gear motorthereisenoughroomto
easilyandsafelyreleasethegateleavesbyhands.
•Makesurethattheproductisinstalledonasolidsurface,sothatit
canbesecurelyfastened.
• Make sure that the installation position is compatible with the
overallsizeoftheproduct.
165
306
250 62
46
Thecorrectopeningmovementofthegateandtheforcethatthe
motorexertstoexecuteit,dependonthepositioninwhichthemotor
andarmbracketsarexed.Therefore,beforeproceedingwith the
installationyoumustcheckcharts 1 and 2 and gure3todene
themaximumopeningangleoftheleaf,thelimitsoftheleafandthe
positionofthexingbrackets.