6-4. CTD9711 穿線 Threading for CTD9711
A
D
B
C
由於某一些因素，導致對縫製效果產生影響，如裁片的厚度及質料、縫線種類及粗細、線跡寬窄的要求
、進給率大小的變化.........等等，故必須經過試車調整後才能找出最佳的縫製效果。
7. 與縫製有關的各項調整 Proper operation adjustment
Due to some reasons will affect the sewing effects. such as thickness of sewing fabrics, different kinds of sewing
threads and its thickness requirements for narrow on wider stitches, the changes of feed ratio etc. Thus, machines
must be adjusted and test running first in order to obtain the best sewing effects.
A
B
C
D
E
用在伸縮尼龍線
When woolly thread used.
E
飾線，Ｅ為下勾線，當下勾針線使用棉線或伸縮尼龍線時，其穿線方法有所不同，如圖所示。
diagram below.
When using cotton tread or nylon thread, the threading is different from other kinds of threads, please refer to the
in the illustration below. For two needle machine, threading is the same except two needle thread.
A,B,C．．． needle thread, D．．． top cover thread, E．．． looper thread, three needle machine is shown
skip stitch, thread breakage and uneven tension.
Threading should be made correctly, please refer referring to the illustration, improper threading might caused
等不良現象，錯誤的穿線是其中一個原因，請依照穿線圖正確的穿線。ABC為擊針線，Ｄ為上裝
要得到最佳的縫製效果，縫線的收放量是一個重要的環節，縫製過程裡斷線、跳針、線跡不穩定
A
C
B
To Next Page
Loading...
Need help?
General
