2. Unscrew the air cleaner clip and
remove the cover.
3. Clean the inside of the air cleaner
housing thoroughly.
4. Replace the filter and check the
housing for damage.
5.
Install the cover and x it with the clip.
td2O731A
(1) Radiator Cap (2) Reservoir Tank
(A) Full (B) Low
6. Install the radiator cap securely.
7. Start and idle the engine for few
minutes.
8. Stop the engine and let it cool.
9. Drain water and cooling system
cleaner and close drain cock.
Then, fill with antifreeze and
water mixture and close radiator
cap securely.
10. Run tractor at idle until up to ope-
rating temperature.
td2O732A
FLUSH COOLING SYSTEM AND CHANGING COOLANT (AJ)
1.
Park the tractor on level ground, stop
the engine and let the engine cool down.
2. To drain coolant, remove the drain
plug from the radiator and turn the
radiator cap to the 1st notch to
release pressure in the radiator.
Then, remove the cap completely.
3. After all coolant is drained, t the
drain plug.
4.
Use clean, fresh water and anti-free-
ze to ll the reservoir tank.
5. Follow the cleaner manufacture’s
instruction.
(1) Drain Plug
CAUTION
Use only a KIOTI genuine l-
ter. If using a product other
than the genuine one, it can
damage the engine internal
section and sensor.
Make sure that no dust enters
the system by installing the
cover rmly.
When removing the filter, be
careful not to let foreign ma-
terial enter the air inlet.
•
•
•
NOTE
When installing the cover, make
sure that the dust collection val-
ve is heading down.
•
To Next Page
Loading...
