HOW TO USE QUICK-TURN FUNCTION
1. To activate the quick-turn function,
press the switch downward.
2. When operating the switch to acti-
vate the quick-turn function, make
sure that the front wheels are in
the straight ahead position.
3. As a safety measure, the quick-
turn function cannot be activated
when the range shift lever is set
to the high speed position and the
vehicle speed is over 6 km/h.
4. Make sure to set the switch to the
2WD or 4WD position before lea-
ving the eld.
5. Be sure to select the 2WD during
driving, as 4WD or quick-turn can
cause an unexpected accident du-
ring driving.
6. Never make a sharp turn during
driving.
4WD OPERATION
The 4WD function is used to increa-
se traction power by driving the front
and rear wheels (4 wheels). To en-
gage the 4WD, press the upper sec-
tion of the 4WD switch. As the 4WD
operation is performed by hydraulic
pressure, a simple operation of the
switch can control it.
The 4WD function is useful under the
following conditions:
1. When strong traction force is re-
quired in a humid area.
2. When towing a trailer or using a
loader.
3. When working on sand.
4. When the tractor is pushed forward
by repulsive force from the rotary
tiller on hard soil.
5. When tilling a eld or moving over
a eld bank.
CAUTION
To avoid accidents:
Do not activate the 4WD fun
-
ction while driving on a road.
The 4WD should not be used
on a paved road as tires can
be worn faster.
While the 4WD is engaged, dri
-
ve the vehicle with low speed
as steering and braking cha-
racteristics may differ.
The 4WD can be activated even
while the vehicle is moving.
However, noise or shift shock
may occur during 4WD enga-
gement in this case. To ensure
safe driving, it is recommended
to engage the 4WD after stop-
ping the machine completely.
•
•
•
To Next Page
Loading...
