BLEEDING FUEL SYSTEM
BLEEDING MUST BE PERFORMED
IN THE FOLLOWING CASES:
1.When the fuel lter or line is re-
moved or disconnected.
2. When tank is completely empty.
3. After the tractor has not been used
for a long period of time
BLEEDING PROCEDURE IS AS FOL-
LOWS:
1.Removethecockfromthefuellter
to bleed the air.
2. Start the engine to run for about 30
seconds and then stop the engine.
3. Turn the fuel cock to open position.
(1) Fuel Cock
(A) Close (B) Open (C) Bleeder
t91Oa40a
(1) Plug
Plug is located at the bottom of the
clutch housing. Moisture can be col-
lected due to change in the internal
temperature. Water can enter into the
clutch housing when driving the tractor
in rain or snow or cleaning the tractor.
If this occurs, remove the clutch hous-
ing to drain the water. Be careful not
to damage the clutch when reinstalling
the plug.
DRAINING CLUTCH HOUSING
t91Oa41a
REPLACING FUSE
Fuses protect the tractor`s electrical
system from potential damage.
A blown fuse indicates that there is an
overload or short somewhere in the
electrical system.
Ifanyofthe fuses should blow,nd
and repair the short and replace with
a new one of the same capacity.
(1) Fuse Box
S76Oa42a
To Next Page
Loading...
