2-16
Plug in Grill
1. This built-in outdoor grill comes with a
power transformer plug assembly for the
grill lights. Plug in the single-prong plug in
the receptacle on the left underside of the
grill.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death or
electrical shock.
2. Plug into a grounded 3-prong outdoor
outlet.
3. The igniter battery is not factory installed.
A 1.5 volt “D” size alkaline battery is lo-
cated in the accessory box on the grill
grate. Install battery at this time following
the instructions in “Replacing the Igniter
Battery” section. (s models only)
4. Gently slide grill completely into outdoor
enclosure.
5. Now go to the “Check and Adjust the Burn-
ers” section.
If Converting to LP Gas
Explosion Hazard
Use a new CSA International approved
“outdoor”gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualied per-
son make sure gas pressure does not
exceed 11” (28 cm) water column.
Examples of a qualied person include:
Licensed heating personnel,
authorized gas company personnel,
and authorized service personnel.
Failure to do so can result in death, ex-
plosion, or re.
IMPORTANT: A 20 lb LP gas fuel tank must be
purchased separately.
IMPORTANT: The gas pressure regulator/hose
assembly supplied with the conversion kit must
be used. Replacement gas pressure regulator/
hose assembly specic to your model, is avail-
able from your outdoor grill dealer.
To Next Page
Loading...
