KitchenAid KFRS271TSS - Installation Instructions

2-10
INSTALLATION INSTRUCTIONS
Style 1 - Freestanding Outdoor Grill
Installation
Excessive Weight Hazard
Use two or more people to move and
install grill.
Failure to do so can result in back or
other injury.
WARNING
1. Unpack grill. Remove all packaging materi-
als and remove grill from wooden skid.
2. Move grill into desired outdoor location.
3. Open the hood.
Attach Side Shelf (on some models)
4. Open doors below grill and remove carton.
Unpack side shelf.
5. Locate 4 screws. Install 2 screws in the
top 2 holes on each side of the grill. Leave
screws away from side of grill about ¼"
(0.64 cm).
6. Install side shelf on left side of the grill.
Position the side shelf so that the large end
of the keyhole slots are over the screws.
Place shelf onto the 2 mounting screws.
Let the shelf slide down so the screws are
in the narrow neck of the slots.
A. Top of side shelf
B. Keyhole slot
C. Front of side shelf
D. Side of grill
A
B
C
D
7. Install the bottom 2 screws and tighten.
8. Tighten the top 2 screws.
Attach Cabinet Doors (on some models)
1. Remove foam wrapping from both cabinet
doors.
2. Position hinge pins on the door with the
hinge brackets on the cabinet. Gently push
down to slide the pins into place.
A. Door hinge pin
B. Hinge bracket
A
B
Remove Packaging Material Inside the
Grill
1. Cut the tiedowns holding the grates to-
gether.
2. Remove condiment shelf, warming shelf
and grill grates from inside the grill and
remove packaging material.
3. Remove foam block and wrap from inside
the grill.
All manuals and user guides at all-guides.com