4-13
REMOVING THE PRESSURE SWITCH
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover and the console
(see page 4-2 for the procedures).
4. Pull the pressure hose off the pressure
switch inlet.
5. Press on the two locking arms at the
bottom of the wire connector, and pull the
connector off the pressure switch termi-
nals.
Pressure Switch
Wire Connector
Pressure Hose
6. Pry the standoff on the wire channel out of
its chassis mounting hole.
7. Turn the pressure switch 90° counter-
clockwise so that the square locking tab is
aligned with the chassis cutout. Pull the
tab out of the cutout, and remove the
switch.
Wire Channel
Rotate 90° CCW
To Next Page