KitchenAid KSB5010 - Appendix C Torrent Blender Screw Torques

- 28 -
Troubleshooting Quick Reference Guide
(continued)
Blender vibrates on work
surface.
Worn, dirty or damaged
Feet.
Replace worn or damaged Base Foot/Feet. Remove any
dirt with a mild soap and water solution.
Jar not fully inserted into
blender housing.
Check the jar to make sure it is fully seated to the tab
and engages with the jar release handle.
Poor belt alignment.
Remove the base and inspect the belt for proper
alignment to the pulleys.
Blender jar leaks
Jar too full (ingredients
pushed out)
Reduce the amount of the ingredients in the jar
Faulty or broken jar
Replace Jar assembly
Faulty jar lid
Replace lid
Appendix C
Torrent Blender Screw Torques
The screw torque values used in the assembly of the Torrent (P2) Blender are as follows:
( in-lb)
 (1) Lever Pivot, Shoulder Screw 30 - 35
 (4) Screws for Lower Housing to Surround Housing 18 - 24
 (1) Screw for Upper Housing to Surround Housing 18 - 24
 (2) Screws for Upper Housing to Upper Housing Cover 18 - 24
 (2) Screws for Power Board to Surround Housing 18 - 24
 (1) Screw for Power Board Ground to Surround Housing 18 - 24
 (1) Screw for Ground Cable to Surround Housing 18 - 24
 (2) Screws for Speaker to Surround Housing 18 - 24
 (4) Screws for Upper Housing Cover to Surround Housing 10 - 15
 (5) Screws for Base to Lower Housing 20 - 25
 (4) Screws for Interlock Switches to Upper Housing Cover 10 - 14
 (1) Screw for Trim Band to Lower Housing 10 - 14
 (3) Screws for Collar to Upper Housing 10 - 14
 (4) Screws for Lower Housing Cover to Lower Housing 10 - 14
 (2) Screws for Upper Housing Cover to Front Housing 18 - 24