Kitvision ESCAPE 4KW - Instructions for use; Turning power on and off; Charging the battery; Inserting the memory card

6 7
Instructions for use
Turning power on and o
1. Long Press the Power/Mode button (3) to turn on the
camera. The Top Operation Indicator (2) will illuminate red.
2. LongpressthePower/ModeButton(3)toturnpowero.
Charging the battery
The camera has a built-in rechargeable lithium battery. Please
fully charge the battery before use.
1. Turnothecamera.
2. Connect the micro USB connector of the USB cable to the
camera and the other end to a PC/mains charger USB port.
3. The Charging Indicator (9) will be solid blue whilst charging.
4. OncefullychargedtheChargingIndicator(9)willturno.
Note: The camera body may be warm after extended use. This is
normal.
Inserting the memory card
The Escape Action Camera doesn’t have any internal memory. To
be able to record video or capture photos using the camera, you
must have your micro SD card inserted (32 GB max, not
included).
1. Ensurethecameraisturnedo.
2. Insert your memory card into the micro SD card slot (5).
3. ThecamerausestheFAT32leformat.IfthemicroSDcardis
incompatible, it will need formatting.
4. To format the card correctly, go to the ‘Changing the Camera
Settings’ section later in this manual and follow the ‘General
Settings’ instructions.