Kitvision ESCAPE 4KW - Using video mode; Recording audio within a video; Using photo mode

10 11
Recording audio within a video
If using the camera with the waterproof case, audio will be
recorded although it will be less audible. For best audio quality,
the camera will need to be used without the case. When using
the camera without a case, please take extra care and make sure
it does not get wet.
Using photo mode
1. Turn on the camera and press the Power/Mode Button (3)
once to select Photo mode.
2. Use the built-in LCD (10) to view your shot, and then press the
Shutter/Ok Button (1) to take a still image.
3. After the image has been taken, the camera will make a
‘shutter’soundeectandthebuilt-inLCD(10)willblinkonce.
Using video mode
1. Turn on the camera, and it will start in Video mode. If in
another mode, press the Power/Mode button (3) until you
reach Video mode.
2. Use the built-in LCD (10) to view your shot, then press the
Shutter/Ok Button (1) to start recording.
3. WhenrecordingtheTopOperationIndicator(2)willash,the
LCD (10) will show a red video icon and will display how long it
has been recording for.
4. Press the Shutter/Ok Button (1) again to stop recording.
Note: The camera will stop recording and save automatically
when the memory capacity is full or it has run out of battery
power.