Klarstein SKYSCRAPER ICE SMART - Getting Started and Operation; Filling the Water Tank

25
EN
START AND OPERATION
Carefully remove all p ckaging materials and retain for future storage/use. Make sure
there is no residual foam left in any of the components. No tools will be required to
assemble this tower evaporative cooler.
Filling the water tank
Fill water into the water tank before using the cooling or humidifying function of the air
cooler. Turn the tank knob to the left, pull the tank halfway out and pour water into the
water tank. Close the water tank again after lling.
Pay attention to the water level when lling
the water tank. The water level should not
be higher than the MAX mark and not lower
than the MIN mark. Use clean water to ll the
water tank. After lling, push the water tank
back into the drawer of the appliance and
lock the water tank.
Note: When used for the rst time, there may be a slight odour and discolouration of
the water. This is not a health hazard.