2
GENERAL SPECIFICATIONS
Klein Tools ET250 is a solid-state, digital voltage and continuity
tester. It measures AC/DC voltages up to 600V and tests for
continuity. Additionally, the ET250 tests GFCI protected circuits to
verify that the GFCI device is functioning appropriately. The tester
includes a backlight and worklight for working in reduced ambient
lighting conditions.
• Operating Altitude: ≤ 6562 ft. (2000 m)
• Relative Humidity: <80% non-condensing
• Operating Temperature: 5°F to 113°F (-15°C to 45°C)
• Storage Temperature: -4°F to 140°F (-20°C to 60°C)
• Battery Type: 3 x 1.5V AAA
• Dimensions: 6.06" x 2.33" x 1.64" (153.8 x 59.2 x 41.6 mm)
• Weight: 6 oz (170 g) without test leads
• Calibration: Accurate for one year
• Standards:
Conforms to EN61326-1:2013, EN61326-2:2013,
UL STD. 61010-1, 61010-2-030 and
61010-2-033.
Certified to CSA STD. C22.2 NO. 61010-1,
61010-2-030 and 61010-2-033
• Pollution degree: 2
• Drop Protection: 9.8 ft. (3m)
• Ingress Protection:
IP53 (except test lead jacks, see WARNINGS)
• Safety Rating: CAT IV 600V, Class 2, Double insulation
CAT IV: Measurement category IV is applicable to test and
measuring circuits connected at the source of the building’s
low-voltage MAINS installation.
• Electromagnetic Environment: IEC
EN61326-1:2013
. This
equipment meets requirements for use in basic and controlled
electromagnetic environments like residential properties,
business premises, and light-industrial locations.
Specifications subject to change.
ENGLISH
To Next Page
Loading...
