6. Installation
The transportation packing is to be removed.
6.1 Indoor installation
The cooler shall be installed in a frost-free room, on a smooth and
horizontal surface having the load-bearing capacity required. The cooler
has to be installed as plug-in box at the customer.
Foundation fixing or use vibration absorbers are not necessarily required.
Observe minimum distances required for maintenance and
servicing operations!
For cooler installation in basement or upper floors of buildings
without adequate emergency exits, standard EN 378 stipulates
requirements to be complied with in terms of protection of staff at
the place of installation.
In view of the existing refrigerant filling volume of the cooler, the
minimum room size must not be less than 15 m³ to make sure that
refrigerant discharge (leakage) in case of damage and subsequent
oxygen displacement has no adverse effects on the health of staff.
The equipment of the cooler with origin parts ensures a safe
operation of the installation.
Modification and changing of origin parts have to be ensue only
after consultation with the manufacturer!
1 Operation side and service side
2 Connection side
To Next Page
Loading...
Need help?
General
