9. Operation
Notice unconditional the safety information and
regulation (see chapter 1.3)!
The cooling device is switched on by means of the mains
voltage and remote control at customer side. The cooler
is switched off by means of the opposed manner as
EMERGENCY STOP circuit.
The cooling device is ready for operation and the
temperature controller takes over the control of the water
outlet temperature.
The set point is adjusted on the temperature controller
(see also appendix - Description Of Temperature
Controller).
(Adjustable value setpoint t
w
2=6 °C)
In systems equipped with a tank (Single or dual -circuit
system) a fault indicator light signals when there is a
water shortage. This indicator light is extinguished
automatically when the water has been topped up to the
MAX.-mark.
To Next Page
Loading...
