To Next Page

To Previous Page

ASSEMBLY INSTRUCTIONS

This product requires assembly. To reduce the risk of injury to persons, never operate without

guards in place. The guard must always be on the tool to protect the user.

1. Unfolding the Shaft

WARNING

• In order to avoid pinching your hands or ngers,

do not hold the shaft at the joints. Do not attempt

to start the trimmer until the shaft has been

locked.

WARNING

• Always remove the battery pack from the

product when you are assembling parts, making

adjustments, cleaning, or when the product is

not in use.t

a. Remove the battery pack from the trimmer.

b. Put your trimmer on the ground and carefully

unfold the shaft. Make sure that the cable is

inside the shaft so that it will not be pinched

when closing the hinge (D).

c. Use the hex wrench (N) to lock the shaft with

the two bolts(O) supplied.

2. Mounting the Guard

WARNING

• Always wear gloves when mounting or replacing

the guard. Be careful of the blade on the guard

and protect your hands from being injured by the

blade.

• Always remove the battery pack from the

product when you are assembling parts, making

adjustments, cleaning, or when the product is

not in use.

a. Remove the battery pack (not included) from

the trimmer.

b. Lift the trimmer head (F) and face it upward;

align the groove on the bottom of the guard (K) with the raised portion on the base of the

trimmer head, and then slide guard onto the base as shown.

c. Make sure that the two mounting holes in the guard are aligned with the two assembly

Kobalt 1157557 User Manual

Questions and Answers: