17
OPERATING INSTRUCTIONS
WARNING
• To prevent serious personal injury, remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material from the unit.
Clean the trimmer after each use
WARNING
• To prevent serious personal injury, remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material from the tool.
a. Clear any grass that may have wrapped itself around the motor shaft or cutting head.
b. Use only a clean, dry, and soft cloth to clean the tool. Never let any liquid get inside the
tool. Never immerse any part of the tool into a liquid.
c. Keep the air vents free from debris at all times.
NOTICE: Obstructing the vents will prevent the air from owing into the motor housing and
may result in overheating or damage to the motor.
WARNING
• Never use water for cleaning your trimmer. Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various types of commercial solvents. Use
clean clothes to remove dirt, dust, oil, grease, etc.
9. Line Replacement
NOTICE: Always use triangle-shaped twisted
nylon cutting line with a size that does not exceed
0.08 in. (2.0 mm). Using line other than that
specied may cause the string trimmer to overheat
or become damaged.
WARNING
• Never use metal-reinforced line, wire, or rope,
etc. These can break off and become dangerous
projectiles.
Wind the spool with new line
WARNING
• To prevent serious personal injury, remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material from the unit.
a. Press the two release tabs on the spool base and remove the spool retainer by pulling it
straight out (Fig. 9a).
b. Use a clean cloth to clean the inner surface of the spool retainer and spool base.
NOTICE: Always clean the spool retainer and spool base before reassembling the cutting head.
c. Check the spool retainer and spool base for worn or damaged parts.
9a
Tab
To Next Page
Loading...
Need help?
General