Kobalt K20LC-26A - Depth-Of-Cut Adjustment; Adjusting the Cutting Angle

13
OPERATING INSTRUCTIONS
 6. Depth-Of-CutAdjustment
WARNING: Always maintain the correct blade-
depth setting.
The correct blade-depth setting for all cuts should not
exceed the thickness of the material being cut by more
than 1/4 in. (6.5 mm).
Greater blade depth will increase the chance of kickback,
and cause the cut to be rough.
a. Remove the battery pack from the saw.
b. Raise the depth-locking lever (
M
) to release it.
c. Determine the desired depth of cut.
d. Hold the base (
J
) at against the workpiece and raise
or lower the saw until the indicator mark on the saw
aligns with the desired depth on the depth scale (
N
).
e. Lower the depth-locking lever to lock it into position.
 7. AdjustingtheCuttingAngle
a. Loosen the bevel-locking knob (
E
), located on the
0° - 50° bevel scale (F) on the base plate (J).
b Tilt the body of the saw until the required angle is
reached (refer to the 0° - 50° bevel scale).
c. Tighten the bevel-locking knob to secure the saw
and angle.
6
M
N
7
E
J
F