14
WARNING
• Verify that the trigger is in the OFF position before connect to the power source.
To turn on and off:
1. Connect machine to the power source.
2. Place one hand on the trigger handle. Place the other
hand on the auxiliary handle (B).
3. Press the lock-out button (G) toward the handle and hold.
4. Squeeze the trigger (H). The hedge trimmer will turn ON.
5. Release the lock-out button (G). The hedge trimmer will
stay on as long as the trigger (H) on the trigger handle is
squeezed ON.
6. The hedge trimmer will stop if you release the trigger (H).
Using the rotating rear handle
1. Place hedge trimmer in a stable position.
2. Make sure that you release the trigger.
3. Press the rotation button (F) and begin turning the rear handle. Release the rotation button and turn
the handle 90 degrees to either side until it clicks into place and the button locks in.
4. To turn the handle back to center, Press the rotation button again, turn the handle slightly, release
the rotation button and continue turning the handle until it locks into place.
Note:
The trigger will not activate until the handle is locked into place.
OPERATING INSTRUCTIONS
3
G
H
B
4
F
To Next Page
Loading...
Need help?
General