21
kobalttools.com
OPERATING INSTRUCTIONS
1
2
G
FILLING THE RESERVOIR WATER
1. Fill the water reservoir with clean tap water to the
max ll line.
Note: The overow drain prevents overlling.
TO CHANGE RESERVOIR WATER
1. Unplug the saw.
2. Remove the overow drain and empty waste water
into a bucket. DO NOT allow the water to splash
onto the ground or around the machine.
3. Rinse the machine thoroughly.
Note: Make sure there is no debris inside the water
level component compartment.
4. Discard the waste water in accordance with local
regulations.
5. Replace with clean water.
To Next Page
Loading...
Need help?
General