27
kobalttools.com
CARE AND MAINTENANCE
WARNING
• When servicing, use only identical Kobalt replacement parts. Use of any other parts may create a
hazard or cause product damage.
• ALWAYS wear eye protection with side shields marked to comply with ANSI 787.I during product
operation. If operation is dusty, also wear a dust mask.
• DO NOT at any time let brake uids, gasoline, petroleum-based products, penetrating oils, etc., come
in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in
serious personal injury.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust,
oil, grease, etc.
LUBRICATION
All of the bearings in this tool are lubricated with a sufcient amount of high grade lubricant for the life
of the unit under normal operating conditions.
CLEANING THE RIP AND MITER GUIDES
During use, the rip and miter guides will become dirty preventing the guides from sliding smoothly. It is
important to clean the saw often.
CLEANING THE SAW
• Unplug the saw.
• Remove the guides and bevel table from the saw.
• Using a small brush and/or water, clean each piece thoroughly removing any trapped debris.
• Remove the overow drain and empty waste water into a bucket. DO NOT allow the water to splash.
onto the ground or around the machine.
• Rinse the machine thoroughly.
• Discard the waste water in accordance with local regulations.
• Replace the drain plug. Tighten securely.
• Dry off the tool.
• Never use water or any other chemical liquids to clean the electrical parts of the machine.
• Keep the ventilation slots clean to prevent overheating of the motor.
• Use a damp soft cloth to clean the water and dust off the tile saw.
To Next Page
Loading...
Need help?
General