What to do if my KOBE IN2630SQB-650-5A Ventilation Hood lights are working, but the motor isn't?
If the lights on your KOBE Ventilation Hood are working but the motor isn't, there are a few potential causes. The control unit or processor board could be defective, in which case it should be replaced. Alternatively, the motor itself or the capacitors might be defective, requiring their replacement.
How to fix a KOBE IN2630SQB-650-5A that is not venting out correctly?
If your KOBE Ventilation Hood isn't venting correctly, several factors could be responsible. The control unit or processor board might be defective and need replacement. Ensure that the range hood is installed with the recommended clearance of 26” to 30” from the cooktop (or 30” to 36” for island hoods). Insufficient make-up air inside the house can also cause this issue, so try opening a window. Finally, check for any obstacles blocking the duct work and remove them.
Why are both the motors and lights not working on my KOBE IN2630SQB-650-5A after installation?
If neither the motors nor the lights are working on your KOBE Ventilation Hood after installation, first ensure that the circuit breaker and the unit's power are turned ON, and use a voltage meter to check the power supply. Also, check and tighten the wire connections to ensure they are secure. Finally, verify the wire continuity from the control unit to the processor board to ensure they are connected.
What causes a KOBE IN2630SQB-650-5A to vibrate and how to fix it?
A vibrating KOBE Ventilation Hood could be due to a defective control unit or processor board, which would need replacing. Another cause could be an unsecured blower system; try tightening the turbine impeller/squirrel cage and air chamber. If the turbine impeller/squirrel cage is unbalanced, it should be replaced.
What to do if the motor is working, but the lights are not working on my KOBE IN2630SQB-650-5A?
If the motor is working but the lights aren't on your KOBE Ventilation Hood, check the hood's installation and tighten the mounting bracket to ensure it's secured. Also, the LED light fixture(s) might be defective and require replacement. Finally, inspect the light wiring(s) for looseness, checking the wire continuity from the processor board to the light transformer and then to the LED light fixture(s).
Why is cold air coming into my home from my KOBE Ventilation Hood?
If cold air is entering your home through the KOBE Ventilation Hood, it could be because the pipe size is smaller than recommended; consider changing the ducting to the manufacturer's suggested size. Also, check the pipe installation to ensure it is properly sealed. Finally, verify the damper installation to ensure it's properly installed or not missing.
Steps to determine proper measurements and clearances before installation.
Guidelines for preparing a custom hood structure for mounting.
Procedures for installing baffle filters and oil tunnel after main mounting.
Instructions for turning the range hood on/off and adjusting fan speed.
How to adjust fan speed levels and understand default settings.
Activating and deactivating the 3-minute automatic fan shutoff feature.
Operating the range hood's LED lighting system and intensity levels.
Explanation and activation of the ECO Mode for improved air quality.
Usage and features of the wireless remote control for the range hood.
Instructions for cleaning the exterior stainless steel surface of the hood.
Guide for cleaning internal baffle filters and oil tunnel.
Contact information and procedures for obtaining warranty service.
General| Brand | KOBE |
|---|---|
| Model | IN2630SQB-650-5A |
| Category | Ventilation Hood |
| Type | Insert |
| Airflow | 650 CFM |
| Lighting | LED |
| Material | Stainless Steel |
| Number of Motors | 1 |
| Width | 30 inches |
| Control Type | Electronic Button |
To Next Page