What to do if lights are working, but the motor is not on my KOBE Deluxe Ventilation Hood?
If your KOBE Ventilation Hood lights are working but the motor isn't, there are a few potential causes. The control panel or processor board might be defective, requiring replacement. Alternatively, the motor itself could be defective and need replacing. Finally, the capacitor(s) might be defective, in which case they should be replaced.
Why is my KOBE Deluxe not venting out correctly?
If your KOBE Ventilation Hood isn't venting correctly, several factors could be responsible. It could be due to a defective control panel or processor board, which would need to be replaced. The range hood might be installed outside the recommended clearance; adjust it to 26” to 30” from the cooktop (or 30” to 36” for an island hood). Insufficient make-up air in the house can also be a cause; open a window to improve performance. Finally, there might be an obstacle blocking the duct work, so ensure that you remove any obstructions.
How to troubleshoot KOBE Deluxe when both motors and lights are not working after installation?
If your KOBE Ventilation Hood isn't working (both motors and lights), here's what to check: * Ensure the circuit breaker and unit's power are ON; use a voltage meter to confirm power supply. * Verify and tighten all wire connections. * Check the wire continuity from the control panel to the processor board.
What to do if the motor is working, but the lights are not working on my KOBE Ventilation Hood?
If your KOBE Ventilation Hood motor is working, but the lights aren't, there could be several reasons. The hood might not be secured properly; check the installation and tighten the mounting bracket. The LED light fixture(s) could be defective, requiring replacement. Alternatively, the light wiring(s) might be loose; check the wire continuity from the processor board to the light transformer and then to the LED light fixture(s).
Why is my KOBE Deluxe vibrating?
If your KOBE Ventilation Hood is vibrating, it could be due to a few reasons. The control panel or processor board may be defective, and require replacement. The blower system might not be secure; try tightening the turbine impeller/squirrel cage and air chamber. Alternatively, the turbine impeller/squirrel cage could be unbalanced and in need of replacement.
How to stop cold air coming into the home from KOBE Deluxe Ventilation Hood?
If cold air is coming into your home from the KOBE Ventilation Hood, consider these possible causes: * The pipe size might be smaller than recommended; change the ducting to match the manufacturer's suggestions. * The pipe connection may not be properly sealed; check the pipe installation. * The damper might be improperly installed or missing; check the damper installation.
General safety measures for installation and operation to prevent fire, electric shock, or injury.
Specific steps to reduce personal injury risk during a kitchen grease fire.
Instructions for calculating installation dimensions based on table references.
Important safety advice regarding sharp edges and using electrical screwdrivers during installation.
Overview of the control panel, power, speed, and light controls.
Detailed guide for activating and managing the ECO Mode for enhanced air quality.
Proper methods for cleaning the hood's exterior surface and finish.
Steps for cleaning removable filters and oil tunnels, including dishwasher safety.
Details on obtaining warranty service and proof of purchase requirements.
Explains the duration and coverage of labor and parts warranties.
Defines what is covered and not covered by the warranty.
Lists conditions under which the product warranty will be invalidated.
Fields to record purchase date, model, and serial number for service.
Contact details for obtaining warranty service and spare parts.
General| Material | Stainless Steel |
|---|---|
| Lighting | LED |
| Available Widths | 30", 36" |
| Speed Levels | 3 |
| Filter Type | Baffle Filter |
To Next Page